Winterhalter UC-XL Příručka pro opravu

Procházejte online nebo si stáhněte Příručka pro opravu pro Myčky nádobí Winterhalter UC-XL. Winterhalter UC-XL Repair manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk

Shrnutí obsahu

Strany 1 - Repair manual

Winterhalter under counter dishwashing machines UC Series Repair manual

Strany 2

8 Exchange collector

Strany 3 - Introduction

9 Procedures Required material: Kit collector Item no. 30 000 169 Tool: no special tool required Important note: The machine must be de-installed

Strany 4 - Drawings

10 Exchange collector (continuation)

Strany 5

11 Procedures (continuation) Disconnect boiler heating element Remove the hose at the back of the boiler Pull off the thermo sensor that is locat

Strany 6 - Adjust parameter P555

12 Exchange collector (continuation)

Strany 7 - Menu-driven first start-up

13 Procedures (continuation) Unplug the circulating pump Pull off the waste water hose that is connected to the upper distributor Loosen clamp at

Strany 8

14 Exchange boiler heating element

Strany 9 - Repair instructions

15 Procedures Required material: Kit heating element 4.9KW with fuse Item no. Kit heating element 6.5KW with fuse item no. 30 000 124 (Japan, Austra

Strany 11 - Procedures

17 Procedures Required material: Kit boiler UC-S: Item no. 30 000 119 UC-M; -L; -XL Item no. 30 000 120 Tool: no special tool required Important no

Strany 12

Table of contents Introduction-------------------------------------------------------------------1 Drawings------------------------------------------

Strany 13 - Procedures (continuation)

18 Exchange the pressure transmitter of the boiler The following manual applies for the UC-M; -L; -XL. In models of the UC-S Series the boiler is loc

Strany 14

19 Procedures Required material: Pressure transmitter Item no. 31 24 044 Tool: no special tool required Observe the safety notes on page 7 Remov

Strany 15 - After the assembly:

20 Exchange tank heating element

Strany 16

21 Procedures Required material: Kit high power heating cartridge 1.8KW Item no. 30 000 122 Kit high power heating cartridge 2.5KW Item no. 30 000 1

Strany 17 - UC-M, UC-L, UC-XL

22 Exchange pump head (dosing device Fluidos)

Strany 18 - Exchange boiler

23 Procedures Required material: Pump head for Fluidos DT (detergent) Item no. 31 02 599 Pump head for Fluidos DT (rinse aid) Item no. 31 02 600 Too

Strany 19

24 Exchange dosing device Fluidos

Strany 20

25 Procedures Required material: Kit Fluidos DT (detergent) Item no. 31 02 597 Kit Fluidos DB (rinse aid) Item no. 31 02 598 Tool: no special tool

Strany 21

26 Exchange integrated water softener

Strany 22

27 Procedures Required material: Kit softener Item no. 83000420 Item no. 83000421 (Japan) Tool: Ring wrench 60003376 Important note: The machine m

Strany 23

1 Introduction The machines of the UC Series are no longer distinguished by their intended use but by their size. The machine name is derived from t

Strany 24

28 Exchange integrated water softener (continuation)

Strany 25

29 Procedures (continuation) Unscrew the terminal block and grounding cable De-install right flute of the strike plate Sideways, unscrew the boil

Strany 26

30 Exchange heat exchanger / radial fan

Strany 27

31 Procedures Required material: Kit heat exchanger Item no. 30 000 190 and / or Kit radial fan Item no. 30 000 189 Tool: Ring wrench 60003376 Impo

Strany 28

32 Exchange heat exchanger / radial fan (continuation)

Strany 29

33 Procedures (continuation) Cut through the belts on the intake socket and remove the hose Installation of the new heat exchanger (item no. 30 000

Strany 30

34 Flow schema Model: Standard (not for UK, Australia) 23451 1: Solenoid valve (4 l/min); cold or warm water 2: Backflow protection type "BPD&q

Strany 31

35 Model: Standard (for UK, Australia) 23451 1: Solenoid valve (4 l/min); cold or warm water 2: Backflow protection type "Airgap" 3: Boile

Strany 32

36 Model: integrated water softener 23456 71 1: Solenoid valve (4 l/min); cold or warm water 2: Backflow protection type "Airgap" 3: Water

Strany 33

37 Model: Energy 324561 1: Solenoid valve (3 l/min); cold water 2: Backflow protection type "Airgap" 3: Heat exchanger 4: Boiler 5: Rinsin

Strany 34

2 Drawings UC-S UC-M UC-L UC-XL UC-S Energy / UC-M Energy UC-L Energy; UC-XL Energy a By removing the feet the machine height is reduced by

Strany 35

38 Model: Energy / integrated water softener 423567 81 1: Solenoid valve (3 l/min); cold water 2: Backflow protection type "Airgap" 3: Wat

Strany 36 - Flow schema

39 Options of the water treatment UC with integrated water softener 123UC Water supply max. 60°C Total hardness: max. 30 °dH Copper concentr.: ma

Strany 37

40 UC with upstream desalination (TE 15 / TE 20 / VE 15 / VE 20) 123T / V UC4 Set parameter: P503 = 1 P511: max. 999 (99.9 m³) 1: Water shut-off val

Strany 38

41 UC with upstream reverse osmosis (RoMatik 160, 210, 420) 12R UC75 6DA3Fe4 1: Water shut-off valve 2: Dirt trap (included in delivery of the UC) 3

Strany 39 - Model: Energy

42 Requirements for a good cleaning result The "Sinner circle” describes the effective impacts in the cleaning process. These can be divided int

Strany 40

43 Factor mechanics Possible causes for a bad cleaning result are: 1. Contaminated or clogged nozzles 2. Contaminated or clogged filter system 3.

Strany 43 - (RoMatik 160, 210, 420)

Winterhalter Gastronom GmbH Commercial Dishwashing Systems Tettnanger Strasse 72 88074 Meckenbeuren · Germany Telephone +49 (0) 75 42 4 02-0 Telef

Strany 44 - Factor chemicals

3 Rotary or alternating current? The machine can be connected both to rotary and alternating current. If the machine is put to another location, the

Strany 45 - Factor temperature

4 Install and connect the mains connection cable Requirements to the mains connection cable 1. Use a cable of the type H07 RN-F or equivalent 2. Se

Strany 46

5 Menu-driven first start-up Shortened version The detailed description can be found in the commissioning regulation of the UC Series. Select langu

Strany 47

6 Save addresses for service and chemicals Enter date of day, time and date of first start-up Summary of the changed parameters Switch on the ma

Strany 48 - Winterhalter

7 Repair instructions Exchange collector --------------------------------------------------page 8 Exchange boiler heating element -------------------

Komentáře k této Příručce

ChrisIncef 27 Apr 2024 | 02:40:29

Hello, im noob :)